Saturday, November 27, 2010

Introduction To Manual Therapy

Dr. Naveen, PT
Guide to PT Practice-                                 
Mobilization/Manipulation = “A manual therapy technique comprised of a continuum of skilled passive movements to joints and/or related soft tissues that are applied at varying speeds and amplitudes, including a small amplitude/high velocity therapeutic movement”
Manipulation Education Committee, June 2003

Maitland Joint Mobilization Grading Scale
Grading based on amplitude of movement & where within available ROM the force is applied.
l  Grade I
        Small amplitude rhythmic oscillating movement at the beginning of range of movement
        Manage pain and spasm
l  Grade II
        Large amplitude rhythmic oscillating movement within midrange of movement
        Manage pain and spasm
        Grades I & II – often used before & after treatment with grades III & IV
l  Grade III
        Large amplitude rhythmic oscillating movement up to point of limitation (PL) in range of movement
        Used to gain motion within the joint
        Stretches capsule & CT structures
l  Grade IV
        Small amplitude rhythmic oscillating movement at very end range of movement
        Used to gain motion within the joint
l  Used when resistance limits movement in absence of pain
        Grade V – (thrust technique) - Manipulation
        Small amplitude, quick thrust at end of range
        Accompanied by popping sound (manipulation)
        Velocity vs. force
        Requires training
Indications for Mobilization
l  Grades I and II - primarily used for pain
        Pain must be treated prior to stiffness
        Painful conditions can be treated daily
        Small amplitude oscillations stimulate mechanoreceptors - limit pain perception
l  Grades III and IV - primarily used to increase motion
        Stiff or hypomobile joints should be treated 3-4 times per week – alternate with active motion exercises
ALWAYS Examine PRIOR to Treatment
l  If limited or painful ROM, examine & decide which tissues are limiting function
l  Determine whether treatment will be directed primarily toward relieving pain or stretching a joint or soft tissue limitation
        Quality of pain when testing ROM helps determine stage of recovery & dosage of techniques
1)  If pain is experienced BEFORE tissue limitation, gentle pain-inhibiting joint techniques may be used
·         Stretching under these circumstances is contraindicated
2)      If pain is experienced CONCURRENTLY with tissue limitation (e.g. pain & limitation that occur when damaged tissue begins to heal) the limitation is treated cautiously – gentle stretching techniques used
3)      If pain is experienced AFTER tissue limitation is met because of stretching of tight capsular tissue, the joint can be stretched aggressively
Joint Positions
l  Resting position
        Maximum joint play - position in which joint capsule and ligaments are most relaxed
        Evaluation and treatment position utilized with hypomobile joints
l  Loose-packed position
        Articulating surfaces are maximally separated
        Joint will exhibit greatest amount of joint play
        Position used for both traction and joint mobilization
           
l  Close-packed position
        Joint surfaces are in maximal contact to each other
        General rule:  Extremes of joint motion are close-packed, & midrange positions are loose-packed.
Joint Mobilization Application
l  All joint mobilizations follow the convex-concave rule
l  Patient should be relaxed
l  Explain purpose of treatment & sensations to expect to patient
l  Evaluate BEFORE & AFTER treatment
l  Stop the treatment if it is too painful for the patient
l  Use proper body mechanics
l  Use gravity to assist the mobilization technique if possible
l  Begin & end treatments with Grade I or II oscillations
Positioning & Stabilization
l  Patient & extremity should be positioned so that the patient can RELAX
l  Initial mobilization is performed in a loose-packed position
        In some cases, the position to use is the one in which the joint is least painful
        Firmly & comfortably stabilize one joint segment, usually the proximal bone
        Hand, belt, assistant
        Prevents unwanted stress & makes the stretch force more specific & effective
Treatment Force & Direction of Movement
l  Treatment force is applied as close to the opposing joint surface as possible
l  The larger the contact surface is, the more comfortable the procedure will be (use flat surface of hand vs. thumb)
l  Direction of movement during treatment is either PARALLEL or PERENDICULAR to the treatment plane
Treatment Direction
l  Treatment plane lies on the concave articulating surface, perpendicular to a line from the center of the convex articulating surface (Kisner& Colby, p. 226 Fig. 6-11)
l  Joint traction techniques are applied perpendicular to the treatment plane
l  Entire bone is moved so that the joint surfaces are separated
l  Gliding techniques are applied parallel to the treatment plane
        Glide in the direction in which the slide would normally occur for the desired motion
        Direction of sliding is easily determined by using the convex-concave rule
        The entire bone is moved so that there is gliding of one joint surface on the other
        When using grade III gliding techniques, a grade I distraction should be used
        If gliding in the restricted direction is too painful, begin gliding mobilizations in the painless direction then progress to gliding in restricted direction when not as painful
l  Reevaluate the joint response the next day or have the patient report at the next visit
        If increased pain, reduce amplitude of oscillations
        If joint is the same or better, perform either of the following:
·         Repeat the same maneuver if goal is to maintain joint play
·         Progress to sustained grade III traction or glides if the goal is to increase joint play
Speed, Rhythm, & Duration of Movements
l  Joint mobilization sessions usually involve:
        3-6 sets of oscillations
        Perform 2-3 oscillations per second
        Lasting 20-60 seconds for tightness
        Lasting 1-2 minutes for pain 2-3 oscillations per second
l  Apply smooth, regular oscillations
l  Vary speed of oscillations for different effects
l  For painful joints, apply intermittent distraction for 7-10 seconds with a few seconds of rest in between for several cycles
l  For restricted joints, apply a minimum of a 6-second stretch force, followed by partial release then repeat with slow, intermittent stretches at 3-4 second intervals
Patient Response
l  May cause soreness
l  Perform joint mobilizations on alternate days to allow soreness to decrease & tissue healing to occur
l  Patient should perform ROM techniques
l  Patient’s joint & ROM should be reassessed after treatment, & again before the next treatment
l  Pain is always the guide



Joint Traction Techniques
l  Technique involving pulling one articulating surface away from another – creating separation
l  Performed perpendicular to treatment plane
l  Used to decrease pain or reduce joint hypomobility
l  Kaltenborn classification system
        Combines traction and mobilization
        Joint looseness = slack
Kaltenborn:
         more gliding---> nearly congruent
         more rolling---> nearly incongruent
         The rolling portion of the combined roll-glide movement always follows the direction of the bone movement
         The gliding portion of the combined roll-glide movement
         whether the moving surface is convex or concave
         If the moving surface is concave---> both the gliding and the bone movement follow the same direction
         If the moving surface is convex---> the gliding follows the opposite direction
Kaltenborn Traction Grading
l  Grade I (loosen)
        Neutralizes pressure in joint without actual surface separation
        Produce pain relief by reducing compressive forces
l  Grade II (tighten or take up slack)
        Separates articulating surfaces, taking up slack or eliminating  play within joint capsule
        Used initially to determine joint sensitivity
l  Grade III (stretch)
        Involves stretching of soft tissue surrounding joint
        Increase mobility in hypomobile joint
l  Grade I traction should be used initially to reduce chance of painful reaction
l  10 second intermittent grade I & II traction can be used
l  Distracting joint surface up to a grade III & releasing allows for return to resting position
l  Grade III traction should be used in conjunction with mobilization glides for hypomobile joints
        Application of grade III traction (loose-pack position)
        Grade III and IV oscillations within pain limitation to decrease hypomobility
Indications:
         Joint dysfunction
         Restriction of accessory joint motion
         Capsuloligamentous tightening
         Internal derangement
         Reflex muscle guarding
         bony blockage
Contraindication
         Absolute:
        bacterial infection,
        neoplasm,
        recent fracture
         Relative
        Joint effusion or inflammation
        Arthrosis ( e.g. degenerative joint disease) if acute, or if causing a bony block to movement to be restored)
        Rheumatoid arthritis
        Osteoporosis
        internal derangement
        General delilitation ( e.g. influenza, pregnancy, chronic disease)








No comments:

Post a Comment